[ts-7000] Re: TS7260 - Can not receive hex characters 11 or 13 from UART. SW flow control

["rustedleecher" <>]

Hello,

--- In  "tsao.terence" <> wrote:
>
> Dear Linux/Unix Masters,
> 
>      I have been trying to receive hex characters using the UART with my 
> TS7260 board.  For some reason, the hex characters 0x11 or 0x13 always gets 
> drop during the transmission.  
> 
>      After 12 hours of debugging, I realized hex characters 0x11 and 0x13 are 
> being used as software flow control DC1 and DC2.  Is there a way to turn off 
> the software flow control so I can FINALLY receive those characters using the 
> uart?  
> 
> Thanks!
>

You are trying to connect your board to your computer using the UART, right?
If so, what software are you using on your PC to communicate with the board?

Regards,
Lucas



------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/