ts-7000
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

[ts-7000] Fixture for TS-7800

from [pugaczewski] [Permanent Link][Original]
To:
Subject: [ts-7000] Fixture for TS-7800
From:
Date: Sat, 29 Aug 2009 12:27:16 +0000 (UTC)


I just purchased a TS-7800.  I want to build a fixture for it.  Are the mounting holes on the board connected to board ground ? Should I connected to the plexiglass based with insulated (plastic) screws and standoffs ?



__._,_.___


Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [ts-7000] Re: Is MultiCast Routing needed to receive MultiCast frames on TS-7250, Neil Cherry
Next by Date:  [ts-7000] Cross compiler on Mac OSX - finally!, bburtan65
Previous by Thread:  [ts-7000] Ts-7800 Debian FTP login, dvir_in_new_z
Next by Thread:  [ts-7000] Re: Fixture for TS-7800, charliem_1216
Indexes:  [Date] [Thread] [Top] [All Lists]
Admin

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU