Hello to all
I have newly started with embedded linux.
My problem is that I can not connect to ts7200 via via web browser.
All configurations are by
per defaults (see below)
What could be the problem.
Thanks
Dr. Mustafa Dülger
The TCP/IP settings for eth0 are
configured in the file ‘/etc/sysconfig/ifcfg-eth0’, here is a
listing :
DEVICE=eth0 # Name of
ethernet interface
IPADDR=192.168.0.50 #
Internet Protocol address of this ethernet interface.
NETMASK=255.255.255.0 # Used
with NETWORK to determine which IP’s are local.
NETWORK=192.168.0.0 # Used
with NETMASK to determine which IP’s are local.
BROADCAST=192.168.0.255 # Broadcast IP for system wide messages.
BOOTPROTO=static # Static IP
(change ‘static’ to ‘DHCP’)
ENABLE=“yes” # Load device on boot.
The TCP/IP network settings are
configured in the file ‘/etc/sysconfig/network_cfg’, here is a
listing:
NETWORKING=yes # Enable
networking on startup
GATEWAY=“192.168.0.1”
# Gateway for internet access.
GW_DEV=eth0 # Default
gateway
HOSTNAME=ts7200 # Host name
of this computer.
BOOTPROTO=no
FORWARD_IPV4=no
DEFRAG_IPV4=no
The TCP/IP name resolution
server is configured in the file ‘/etc/resolv.conf’, here is a
listing:
Nameserver 192.168.0.1 #
Name server for domain name lookups.
To access the web server, open a
web browser and enter “192.168.0.50” as the address.
Von:
[ Im Auftrag von Matthew Harrell
Gesendet: Sonntag, 31. Mai 2009
02:46
An:
Betreff: [ts-7000] Re: 2.6.21
kernel on a ts-7200?
> This
appears to me to mean that I shouldnt try to load
2.6.21 on this
> guy? Is there a dist of Debian for the old (2.4) kernel?
Just build a smaller kernel. It will work fine if you shrink it down
__._,_.___
![]()
__,_._,___