gnloch wrote:
> Hi all...
>
> Anybody knows if is possible to connect 2 ts-dio24 to a ts-7000 board?
>
> If is possible, how to do it?
The boards will stack, you just need to make sure the jumpers are set so
as to avoid conflicting I/O addresses. For example if one board has
JP1 and JP2 off (base address 0x100) and the other has JP1 off and JP2
on (base address 0x108), assuming you don't have any additional boards
at either of those addresses.
(reference: http://www.embeddedarm.com/documentation/ts-dio24-manual.pdf)
> thx
______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16525 East Laser Drive
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|