I see you asked in a previous question with who it is interfaced.
Well it's tied to EP9302 via 3 pins , SPI_CLK , SPI_MISO and pin with
net label DIO_17 that is used for Chip select. You can also take a
look at the schematics located at :
http://www.embeddedarm.com/documentation/ts-7300-schematic.pdf
It's on the first page.
Best regards ,
Eugen
--- In "pointdexter67" <>
wrote:
>
> --- In "K" <kailashrt@> wrote:
>
>
> Hy Kaliash ,
>
> The temperature sensor is TMP124 and it's data sheet can be located
> at the following address:
>
> http://search.datasheetcatalog.net/key/TMP124
>
> On the board this IC "should" be situated near the SPI boot memory.
> There are two footprints for integrated circuits U6 and U4. The
> temperature sensor would be U4 but on my board this device is not
> welded. It is probably that is absent on your board also but you
> could buy this IC and weld it by yourself.It's not complicated.
>
> Best regards ,
>
> Eugen
>
>
>
> >
> > Hello All,
> > Can someone please tell me where the OP-TEMPSENSE sensor
probably
> be
> > located on TS 7300 board?
> >
> >
> > Thanks
> > Kailash
> >
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|