--- In Eddie Dawydiuk <> wrote:
>
> > But I can't get it to load hda1:/boot/vmlinuz. I tried this command
> > (which wasn't in the manual but I found in this list somewhere):
> >
> > RedBoot> load -r -b 0x00218000 -m disk hda1:/boot/vmlinuz
> >
> > e2fs_open: e2fs_inode_lookup failed
> >
> > Can't load 'hda1:/boot/vmlinuz': Can't open file
>
> Take a look at the manual, it should clear things up.
> http://www.embeddedarm.com/Manuals/linuxarm-guide-rev2.2.pdf
>
>
> --
> Best Regards,
> ________________________________________________________________
> Eddie Dawydiuk, Technologic Systems | voice: (480) 837-5200
> 16610 East Laser Drive Suite 10 | fax: (480) 837-5300
> Fountain Hills, AZ 85268 | web: www.embeddedARM.com
>
I realize this is an old thread and have looked at the manual. I think I bit
off more than I
can chew but am giving it one more time before giving up. I have a TS7200
I want to boot from a CF card since I am worried about bricking the board and
would for
other reasons that go with the final goal (a data acquisition system for my
motorcycle).
When I load the kernel though it fails with the above command. I have Sarge on
a 1GB
ext2 formatted CF card with the kernel at /boot/zimage-7200-ts11 and copied the
modules of 2.4..26-ts11 into /lib/modules.
When I attempt to boot using "load -r -b 0x00218000 -m disk hda1:/boot/zimage-
7200-ts11" I get "e2fs_open: e2fs_inode_lookup failed" my boot rom is 1.05
which is
older but I am not sure how to get at a replacement from reboot if the CF card
fails...
(maybe put it in from the TS side)
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|