[ts-7000] WIFI K2.6 7300

["gu_raposo" <>]

Hi there,
i am trying to use wifi iogear in a TS7300 with kernel 2.6. I used
this in kernel 2.4, but i am changing the kernel and i having problems
with it.
My first problem was the zd1211b_ub (that is the firmware of the chip)
that was not is my kernel ( /lib/firmware/zd1211/..) i found it on
internet and put in right place. Now my board loads the modules but i
can not turn on the wi.fi. As follows ...

DEMESG
 usbdev1.2_ep01: ep_device_release called for usbdev1.2_ep01
 usbdev1.2_ep82: ep_device_release called for usbdev1.2_ep82
 usbdev1.2_ep83: ep_device_release called for usbdev1.2_ep83
 usbdev1.2_ep04: ep_device_release called for usbdev1.2_ep04
zd1211rw 1-1:1.0: firmware version 4725
zd1211rw 1-1:1.0: zd1211b chip 0ace:1215 v4810 full 00-02-72 AL2230_RF
pa0 g--NS
zd1211rw 1-1:1.0: eth1

IFCONFIG

eth0      Link encap:Ethernet  HWaddr 00:D0:69:41:12:E6  
          inet addr:192.168.0.10  Bcast:192.168.0.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:940 errors:0 dropped:0 overruns:0 frame:0
          TX packets:180 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:119897 (117.0 KiB)  TX bytes:25485 (24.8 KiB)

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)

IWCONFIG
ts7000:~# iwconfig 
lo        no wireless extensions.
eth0      no wireless extensions.

eth2      IEEE 802.11b/g  ESSID:off/any  Nickname:"zd1211"
          Mode:Managed  Access Point: Invalid   
          Encryption key:off
          Link Quality:0/100  Signal level:-144 dBm  Noise level:-256 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

IFUP ETH2
ts7000:~# ifup eth2
Ignoring unknown interface eth2=eth2


Does anyone has some ideia to make it works ???

Regards 
Gustavo



------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/