allamack17 wrote:
> I want to use two ts7kv cards with my ts-7800 board. I've loaded both
> cards using load_ts7kv but now I don't know how to load the drivers
> for both boards. When I do insmod <driver>.ko it only gets loaded for
> one board. What parameters should I use to make it load for both boards?
Unfortunately it appears that the ts7kvfb module only supports a single
board. It doesn't look like this would be too hard to change - what is
happening is that the ts7kvfb_detect_board() function is iterating
through all possible I/O addresses until it detects a board, at which
point it stops looking. Probably putting in some kind of parameter
variable to over-ride this detection and use a specified set of
addresses would be what is needed.
______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16610 East Laser Drive #10
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|