I am trying to capture video from my Lego cam with the TS-7800. I am
using TS's 2.6.21 kernel with the default config. I have built the
qc-usb driver and it loaded fine. However capturing video doesn't
work. When I try to capture video, the activity led on the cam turns
on, off and again on and stays that way during the 'capture'. However
no frames are captured. The command "cat /dev/video0" outputs garbage
on my PC, but nothing on the board. Dmesg says:
Linux video capture interface: v2.00
usbcore: registered new interface driver quickcam
usb 2-1: new full speed USB device using mv5182_ehci and address 2
usb 2-1: configuration #1 chosen from 1 choice
quickcam: QuickCam USB camera found (driver version QuickCam USB 0.6.6
$Date: 2006/11/04 08:38:14 $)
quickcam: Kernel:2.6.21-ts bus:2 class:FF subclass:FF vendor:046D
product:0850
quickcam: Sensor VV6410 detected
quickcam: Registered device: /dev/video0
and there are no errors. The driver works on the TS-7400 with the same
2.6 kernel.
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|