ts-7000
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [ts-7000] Keypad.c ...Key board routine

from [LaksCEO] [Permanent Link][Original]
To: <>
Subject: Re: [ts-7000] Keypad.c ...Key board routine
From: "LaksCEO" <>
Date: Mon, 10 Mar 2008 15:01:13 +0530
Hi Jim
 
when you have zeros in the first case it means all zeros for the 4 bits and you left shift one time it is again zeros am i right
in the second case when pos = 1 if you left shift it is 2
and when you have pos = 2 if you left shift it becomes 4
and when you have pos = 3 if you left shift it becomes 6 is it not?
-laks
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [ts-7000] Re: SD card corruption, please help!, Jim Jackson
Next by Date:  Re: [ts-7000] Keypad.c ...Key board routine, LaksCEO
Previous by Thread:  Re: [ts-7000] Keypad.c ...Key board routine, Jim Jackson
Next by Thread:  Re: [ts-7000] Keypad.c ...Key board routine, LaksCEO
Indexes:  [Date] [Thread] [Top] [All Lists]
Admin

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU