[ts-7000] TS-7300 Kernel re-build won't reboot

["Andy Mercier" <>]

Hi,

I followed the kernel compiling instructions in the TS document "Linux
for ARM on TS-7000, 2.2 Dec. 2006", and
http://www.ovro.caltech.edu/~dwh/ts7300/ts7300.pdf - thanks Dave.
After putting the kernel on the SD card it will boot correctly and run
but it won't reboot.

If I use the reboot command at the command line or Ctrl-Alt-Del from
the USB keyboard it doesn't reboot. Using the reboot command finishes
output with "Rebooting... " and just sits there. All output that I'm
describing is on the VGA output.

I did use the commands "make ts7300_config; make oldconfig" to build
the kernel with no modifications and the building was done with
Kegel's Crosstools from a Linux host.

Any ideas what would cause reboot to fail to, uh, reboot?

----
Andy



 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/