Re: [ts-7000] Installing the TS-CAN1 on a TS-7800 board

[Ronald Gomes <>]

Hello,

 

You have to specify the hw,irq,io parameters to the driver according to TS-CAN1 jumper configuration:

"hw" accepts tscan1,ts7kv

"irq" accepts values 5,6,7

"io" accepts values 150,158,160,168

 

Therefore, for a TS-CAN1 board with only jumper 5 ON (irq7), the following command must work with a TS-7800:

insmod lincan.ko hw=tscan1,io=150,irq=7

 

Website and documentation will be updated soon.

 

Regards,

Ronald.

 

 

Jason Field <> escreveu:

Hi all,

(Apologies if this double posts - I tried the web interface and I think it went a bit mad :) )

I'm trying to get a TS-CAN1 board working using kernel 2.6 on a TS-7800. I found the correct driver from a post on this board[1], but I can't seem to get it to install correctly with modprobe. Are there any docs about installing the new modules under kernel 2.6? I've had a hunt about but I can't find any, and the 'Getting started with TS-CAN1' document from the website refers to the old driver.

Any help greatly appreciated!

Cheers,

Jason

[1] http://tech.groups.yahoo.com/group/ts-7000/message/9160

---

Abra sua conta no Yahoo! Mail, o único sem limite de espaço para armazenamento!

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___