Re: [ts-7000] using GSM module

[Samuel <>]

Robin,

Maybe you can check if the code is work as it should with the terminal emulator like hyper term or something see if you get a  "AT". remember that you need to put in the return carriage else it would not work!

Samuel

----- Original Message ----
From: lerougegorge <>
To:
Sent: Wednesday, July 18, 2007 8:14:01 AM
Subject: [ts-7000] using GSM module

I'm trying to test the GSM modem module (TS-GSM1) on COM2. Here is my
setup:

- TS-7260 running Debian from the supplied USB drive
- TS-GSM1 installed.
- on JP Jumpers J1 and J5 are ON all others are OFF (goal is COM2
communications)
- IRQ7 ON (all other IRQ off)

I'm using picocom, so I execute the following: ttyAM1 -b 9600

Which gives the response:
port is : ttyAM1

flowcontrol : none

baudrate is : 9600

parity is : none

databits are : 8

escape is : C-a

noinit is : no

noreset is : no

nolock is : no

send_cmd is : ascii_xfr -s -v -l10

receive_cmd is : rz -vv



Terminal ready

(end response)

However, "AT" and enter gives me nothing. Any ideas on how to
troubleshoot this? I would just like to get an "OK" back, I could make
it work from there. Thanks in advance.

Best,
Robinvv

---

Get the Yahoo! toolbar and be alerted to new email wherever you're surfing. 
__._,_.___

SPONSORED LINKS

Single board computer	Hardware	Computer running slow
Linux os	Single board

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___