I have a TS-7200 with a TS-GSM1 and GR64 GPRS modem.
The jumper seetings on the TS-GSM board are configured to use COM8
I/O2A0 and irq 7.
I assume that on start-up the new com-port must show up in /dev/tts/
as a single digit other than 0. However, all I currently get is
/dev/tts/0.
Would appreciate if someone could confirm the right configuration
procedure for ts-linux:
- I set the TS-GSM1 jumpers to use COM8 I/O 2A0 and irq 7;
- I do not insmod additional modules - tsuart.o should suffice;
- Kernel detects a new comport and creates /dev/tts/<something>0>;
- I create a device node /dev/ttyAM07 with major number 204, minor 23
(or do I just link it to /dev/tts/<something>0>?)
- run setserial /dev/ttyAM7 port 2A0 irq 7 (the latter currently fails
reporting the device absent)
Thanks
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|