I am new with TS-7400 board (received yesterday...), but I think that
you need to boot on an SD card or USB dongle linux distribution.
>From it, I think you will be able to access the partition #3 of the
onboard flash, format it and copy the small linux distribution on it.
Sorry for my poor english I am french ;)
Regards,
Cyril HAENEL
--- In "phillipchungnz" <>
wrote:
>
> Hi,
>
> This morning I put the TS-9441 jumper board onto an TS-7400, turned on
> the TS-7400, and entered the commands:
>
> $ insmod ts7xxx_nand.o
> Using ts7xxx_nand.o
> $
> $ fdisk -l /dev/mtdblock/3
>
> Disk /dev/mtdblock/3: 29 MB, 29343744 bytes
> 255 heads, 63 sectors/track, 3 cylinders
> Units = cylinders of 16065 * 512 = 8225280 bytes
>
> Disk /dev/mtdblock/3 doesn't contain a valid partition table
> $
>
> Now when I do the same, I get:
>
> $ insmod ts7xxx_nand.o
> Using ts7xxx_nand.o
> $
> $ fdisk -l /dev/mtdblock/3
> $
>
> How do I restore /dev/mtdblock/3? Without it, the TS-7400 doesn't boot
> up because it can mount a filesystem on to /dev/mtdblock/3.
>
>
> I've tried entering:
>
> $ save
> Saving ramdisk to flash, please do not remove power until finished.
> $ fdisk -l /dev/mtdblock/3
> $
>
> with the TS-9441 jumper board on.
>
> Thanks for any assistance.
>
> Phillip
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|