Hello,
> I noticed that on the TS7260 the first 3 ADC are used by the system to
> monitor the votages. i am powering the TS7260 a lipo battery so i
> need to monitor the input voltage.
>
> Can user code still read these ADC?
Yes user code can read from those ADCs.
> if so.....
> I would assume we would not have to init them since the system should
> have already done that. Is that correct?
No, you would still need to initialize them.
> also i did not find in the docs which voltage channel 0 monitors?
> channel 1? channel2?
>From the schematic I see the following.
channel 0: Power In(voltage dividor)
channel 1: PC/104 5V(voltage dividor)
channel 2: DIO2 header
channel 3: 1.8V
channel 4: DIO2 header
//Eddie
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|