If your Com1 is working with your current port settings make sure com2
is enabled in /etc/inittab and is set to the same values
For my TS-7250 i have :
-------------------------------------------------------
T0:23:respawn:/sbin/getty -L ttyAM0 115200 vt100
T1:23:respawn:/sbin/getty -L ttyAM1 115200 vt100
-------------------------------------------------------
in my /etc/inittab
This means that after powerup the init process starts looking for
logins from both serial ports.
If you make changes to inittab and wants to try them right away you
kan kill the init-process with the HUP signal. that will cause it to
reread it's settings.
Try for example "kill -s HUP 1" (1 is usually the init-process number)
Good Luck
Per Öberg
--- In "Elizabeth" <> wrote:
>
>
> Hello everybody,
>
> I have a problem when trying to connect from the COM2 of a TS7300 to a
> computer. I place the jumper in pins 2 & 4 and when I power on I just
> get an output of what is been executed in the TS but I cann't write or
> execute any command. Can someone tell me how to use the COM2 in the same
> way that COM1 is used?
>
> Thanks for any help
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|