>Hi all,
>I have orderer a TS-7400 board a couple of weeks ago and yesterday I
>received the parcel, with the TS-9441, the power supply
>(PS-5VDC-2_5REG, 5VDC 2.5AMP Regulated Power Supply (100-240V)) and
>all the cables. The power supply in the box does not fit in the plug,
>how could I connect it to the board? I looked in the web page, but I
>could not find any hints...
>
>Furthermore, the TS-9441 board "occupies" both the upper 26-pin header
>and the lower 40-pin header, leaving no free pins on the TS-7400. How
>is it possible to use the TS-7400's DIO pins when the TS-9441 is used
>for console output?
>
>Thanks a lot
>Andrea
>
>
The TS-9441 is used only for development, if you require use of the
console in a production environment may I sujest looking into the Maxim
MAX-232 chip for TTL to RS232 level conversion. It's fairly simple to
wire up and if you look around other chips in that family have built in
capacitors as well (MAX-233 I think?)
Jason
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|