[ts-7000] hot-swapping JP2

["gunghoiguana" <>]

Here's another obscure one:

On the ts-7260, what's the word on setting jumper JP2 (the console
enable) while the board is on?  Is that safe?

I ask because I have a relatively dumb device connected to COM1, and I
need the console disabled at boot time because it prints stuff that
the device misinterprets as commands--a few lines go to COM1 even when
the console is swapped to COM2.  It's not a problem to just disable
the console at boot time and connect JP2 if I need it later (usually
unnecessary, since I can log in over ethernet).

If it's not safe to set JP2 while hot, is there a way to prevent
anything from printing to COM1 while JP2 is on?

Thanks,

Brian





 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/