Jim,
Thanks!
I was missing the msdos module. After that was installed I was able to
mount the cf card using the /dev..../part1 device.
Again, thanks.
Tom
Jim Jackson wrote:
>
>On Fri, 31 Mar 2006, Tom Hoover wrote:
>
>
>
>>I'm actually using a TS-7200. I was stupid and just types the group name
>>instead of my actual board.
>>
>>The compact flash card is fat32 - my problem is what device to I use to
>>mount it?
>>
>>
>
>Assuming you are using the on-board flash image, then
>First you'll need to load the modules for fat etc support
>
> insmod fat
> insmod vfat
> insmod msdos
>
>The devfs file system makes some of devices a bit opaque - it should be
>something simple like /dev/hda1 but instead is
>
> /dev/ide/host0/bus0/target0/lun0/part1
>
>that is, if the cfdisk has a partition table describing just one
>partition. If there is no partition table and the whole disk has been
>formatted then it will be
>
> /dev/ide/host0/bus0/target0/lun0/disc
>
>Just to confuse, redboot references the cfdisk as /dev/hda1 etc
>I believe the full debian system that technologics provides, does not use
>devfs, and so the cfdisk is referenced as the usual /dev/hda1 etc there
>too.
>
>
>
>>I also have the same problem with USB disk drives - I don't know what
>>device to mount.
>>
>>
>
>sorry can't help you there - usb storage on the ts7200 is on my very
>long todo list.
>
>Jim
>
>
>
>Yahoo! Groups Links
>
>
>
>
>
>
>
>
>
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|