[ts-7000] GPIO IRQ problems

[Andy Gryc <>]

Hi all,

I'm writing a device driver to be triggered off one of the GPIO port b 
(DIO 4, specifically) interrupts.  The problem is when I get to calling 
request_irq with the GPIOINT interrupt (59), I get back -22.  I 
interpret that as "EINVAL"--i.e. the value is out of range?

It certainly isn't because that IRQ is already taken: if I dump 
/proc/interrupts, I've got 4 for the timer, 39 for the Ethernet, and 52 
for the UART, but nothing else.

Am I doing something wrong, or is this kernel not designed to handle 
irqs higher than 52?  If that's the case, that's really bad; it 
basically means I can't write my device driver unless I get a new 
kernel. :-(

--Andy Gryc 


 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/