Bernie,
Unfortunately, I have also had some glitches, they can occur on either righ=
t or left but
never at the same time. The glitch is electronic in that is spread across t=
he full
frequency spectrum and looks very similar to those you can get on the PC wh=
en your audio
editor gets interrupted by another process or when the latency is not setup=
correctly.
I have produced a sonograph of a couple of typical pops here:
http://www.mikeoates.org/arl/misc/ls-10_pop.jpg
The left pop is 0.02 seconds in length while the one on the right is 0.01 s=
econds.
I was thinking it may have been some electrical interference because the ba=
ttery box I am
using for my external mics is not screened. In fact I am right now this wee=
kend building
another one in a metal box in the hope that it solves the problem. Now I am=
wondering if
it will :(
The glitch or pop sound has happened when recording inside in the warm and =
outside in
freezing conditions. It has also occurred at the two recording settings I u=
se: 44.1kHz
24bit and 96kHz 24bit. The image above is from a 96kHz recording.
I should add that it only occurs on a small number of recordings, most are =
fine.
I have also got another problem, that I can't replicate, it has happened ju=
st twice, in
that (again using the same battery box and external mics) the Left channel =
recorded at 6dB
lower. This is from the moment of starting that recording, even when I had =
just done
previous recordings that were fine and all I did was press stop, them start=
record again.
I too am now rather concerned that there may be a fault with the machine. B=
ut as I only
ever use it with external mics, I have not been able to rule that part out =
yet.
Regards,
Mike
>I haven't be following posts on the LS-10 closely so forgive if this
>is a repeat.
>
>A student of mine just purchased one on my recommendation and when we
>came back from a short field trip there were a number of disturbing
>pops and clicks in the clip that sounded electronic or like sampling
>errors. She was recording 44.1/24bit and was not overloading. Any
>similar experience with LS-10 owners in the group? If so, have you
>identified the problem?
>
>Bernie
>
>
>Wild Sanctuary
>POB 536
>Glen Ellen, CA 95442
>707-996-6677
>http://www.wildsanctuary.com
>
>Google Earth zooms: http://earth.wildsanctuary.com
>SKYPE: biophony
>
>
>
|